allowable strength

Allowable stress and strength design method of masonry code in the United states& flexure design

美国砌体规范的容许应力与强度设计方法&梁的抗弯设计

Strength Design values may be converted to Allowable Stress Design values.

设计要求、强度设计值可转换为许用应力设计值。

By analyzed interactions of combined limit pipe load components, simplified check formula for pipe load strength are put forward and the calculation method of relevant allowable pipe load values based on shell finite element analysis is presented as well.

通过对组合极限接管载荷分量相互关系的分析，提出了接管载荷强度验算简化公式和以壳结构有限元应力分析为基础的许用接管载荷计算方法。

The requirements for allowable stress design of masonry were retained and strength design provisions were first included in the American Building Code Requirements for Masonry Structures ( ACI 530-02/ ASCE 5-02/ TMS 402-02) in the 2002 edition.

美国砌体结构建筑规范（ACI530~02/ASCE5-02/TMS402-02），2002年规范修订版在容许应力设计原理的基础上，首次给出了砌体结构强度设计准则规定。

Applying strength theory, established the strength conditions of steel wire, rubber, and the shear strength condition of steel wire and rubber, and obtained the maximum allowable pull-out load of anchor.

应用强度理论，建立了锚杆体中钢丝、橡胶的强度条件及钢丝与橡胶的剪切强度条件，得出锚杆的最大许用拉拔载荷。